Please wait a minute...
材料研究学报  2004, Vol. 18 Issue (2): 139-143    
  论文 本期目录 | 过刊浏览 |
循环温度范围对Ti--6--22--22合金热机械疲劳行为的影响
虞忠良;李守新;刘羽寅;雷家峰
中国科学院金属研究所沈阳材料科学国家
Effects of cyclic temperature range on thermo-mechanical fatigue behavior of Ti-6-22-22 alloy
;;;
联合
引用本文:

虞忠良; 李守新; 刘羽寅; 雷家峰 . 循环温度范围对Ti--6--22--22合金热机械疲劳行为的影响[J]. 材料研究学报, 2004, 18(2): 139-143.
, , , . Effects of cyclic temperature range on thermo-mechanical fatigue behavior of Ti-6-22-22 alloy[J]. Chin J Mater Res, 2004, 18(2): 139-143.

全文: PDF(1871 KB)  
摘要: 采用拉压对称的机械应变控制, 研究了Ti-6-22-22合金在200~400℃和200~520℃两个温度范围的热机械疲劳(TMF)行为. 结果表明, 在200~400℃内, 同相和反相热机械疲劳寿命均高于400℃等温疲劳寿命; 在200~520℃范围, 反相热机械疲劳寿命明显低于520℃等温疲劳寿命. 在两个温度范围内, 热机械疲劳的循环应力都与相应等温疲劳的循环应力响应有关. 纵向剖面金相观察表明, 520℃时等温疲劳表面的裂纹更长. 循环温度范围扩大导致环境破坏作用增强是热机械疲劳具有明显破坏作用的原因.
关键词 金属材料Ti-6-22-22合金热机械疲劳等温    
Abstract:The thermo--mechanical fatigue (TMF) behaviors of Ti--6--22--22 alloy were investigated in full reverse mechanical strain control in the temperature ranges from 200 to 400℃ and 200 to 520℃. Experimental results indicate that from 200 to 400℃, the fatigue lifes of in phase and out of phase are longer than that of isothermal fatigue (IF) at 400℃; from 200℃ to 520℃, the fatigue life of out--of--phase is much shorter than that of IF at 520℃. The amplitude of cyclic stress of TMF is related to the maximum and minimum temperatures of TMF in the two cyclic temperature ranges. Observations of fracture surface by longitudinal sections by metallography reveal that longer surface cracks appear under IF at 520℃. The reason for obvious detrimental effects of TMF may result from the enhanced environmental damage due to the increase of cyclic temperature range.
Key wordsmetallic materials    Ti-6-22-22    thermo-mechanical fatigue    isothermal fatigue    inphase    out of phase
收稿日期: 2004-05-21     
ZTFLH:  TG115  
1 X.D.Zhang, J.M.K.Wiezorek, W.A.Ⅲ Baeslack, D.J.Evans, H.L.Fraser, Acta Metall, 46, 4485(1998)
2 R.W.Neu, H.Sehitoglu, Metall.Trans., A20,1755(1989)
3 L.Lawson, M.E.Fine, D.Jeannote, Metall.Trans.,A22,1059(1991)
4 R.Zauter, H.J.Christ, H.Mughrabi,Metall.Trans., A25, 401(1994)
5 L.Liang, R.M.Pellox, X.H.Xie, Chin. J. Sci. Tech., 5, 1(1989)
6 P.Potozky, H.J.Maier, H.J.Christ, Metall.Trans., A29, 2995(1998)
7 H.J.Maier, R.G.Peteruk, H.J.Christ, Metall.Trans., A31,431(2000)
8 Z.L.Yu, S.X.Li, J.F.Lei, Y.Y.Liu, Acta Metall. Sin., 38, 290(2002)
9 J.Mendez, In: Blenkshop P A, Evans W J, Flower H M eds., Titanium'95 Science and Technology(London,The Institute of Materials,1996) p.285
10 V.S.Bhattachar,D.C.Stouffer,Trans. ASME,115,358(1993)
11 S.Lesterlin,C.Sarrazin-Baudoux,J.Petit,Scr.Mater.,34,651(1996)
[1] 毛建军, 富童, 潘虎成, 滕常青, 张伟, 谢东升, 吴璐. AlNbMoZrB系难熔高熵合金的Kr离子辐照损伤行为[J]. 材料研究学报, 2023, 37(9): 641-648.
[2] 宋莉芳, 闫佳豪, 张佃康, 薛程, 夏慧芸, 牛艳辉. 碱金属掺杂MIL125CO2 吸附性能[J]. 材料研究学报, 2023, 37(9): 649-654.
[3] 赵政翔, 廖露海, 徐芳泓, 张威, 李静媛. 超级奥氏体不锈钢24Cr-22Ni-7Mo-0.4N的热变形行为及其组织演变[J]. 材料研究学报, 2023, 37(9): 655-667.
[4] 邵鸿媚, 崔勇, 徐文迪, 张伟, 申晓毅, 翟玉春. 空心球形AlOOH的无模板水热制备和吸附性能[J]. 材料研究学报, 2023, 37(9): 675-684.
[5] 幸定琴, 涂坚, 罗森, 周志明. C含量对VCoNi中熵合金微观组织和性能的影响[J]. 材料研究学报, 2023, 37(9): 685-696.
[6] 欧阳康昕, 周达, 杨宇帆, 张磊. LPSOMg-Y-Er-Ni合金的组织和拉伸性能[J]. 材料研究学报, 2023, 37(9): 697-705.
[7] 徐利君, 郑策, 冯小辉, 黄秋燕, 李应举, 杨院生. 定向再结晶对热轧态Cu71Al18Mn11合金的组织和超弹性性能的影响[J]. 材料研究学报, 2023, 37(8): 571-580.
[8] 熊诗琪, 刘恩泽, 谭政, 宁礼奎, 佟健, 郑志, 李海英. 固溶处理对一种低偏析高温合金组织的影响[J]. 材料研究学报, 2023, 37(8): 603-613.
[9] 刘继浩, 迟宏宵, 武会宾, 马党参, 周健, 徐辉霞. 喷射成形M3高速钢热处理过程中组织的演变和硬度偏低问题[J]. 材料研究学报, 2023, 37(8): 625-632.
[10] 由宝栋, 朱明伟, 杨鹏举, 何杰. 合金相分离制备多孔金属材料的研究进展[J]. 材料研究学报, 2023, 37(8): 561-570.
[11] 任富彦, 欧阳二明. g-C3N4 改性Bi2O3 对盐酸四环素的光催化降解[J]. 材料研究学报, 2023, 37(8): 633-640.
[12] 王昊, 崔君军, 赵明久. 镍基高温合金GH3536带箔材的再结晶与晶粒长大行为[J]. 材料研究学报, 2023, 37(7): 535-542.
[13] 刘明珠, 樊娆, 张萧宇, 马泽元, 梁城洋, 曹颖, 耿仕通, 李玲. SnO2 作散射层的光阳极膜厚对量子点染料敏化太阳能电池光电性能的影响[J]. 材料研究学报, 2023, 37(7): 554-560.
[14] 秦鹤勇, 李振团, 赵光普, 张文云, 张晓敏. 固溶温度对GH4742合金力学性能及γ' 相的影响[J]. 材料研究学报, 2023, 37(7): 502-510.
[15] 刘天福, 张滨, 张均锋, 徐强, 宋竹满, 张广平. 缺口应力集中系数对TC4 ELI合金低周疲劳性能的影响[J]. 材料研究学报, 2023, 37(7): 511-522.