Please wait a minute...
材料研究学报  2003, Vol. 17 Issue (1): 20-24    
  论文 本期目录 | 过刊浏览 |
纳米γ-Ni-Fe合金的磁电阻
刘银; 秦晓英;张明旭
中国科学院固体物理研究所内耗与固体缺陷开放实验室
引用本文:

刘银; 秦晓英; 张明旭 . 纳米γ-Ni-Fe合金的磁电阻[J]. 材料研究学报, 2003, 17(1): 20-24.

全文: PDF(917 KB)  
摘要: 用机械球磨Fe2 O3--NiO氧化物和氢气还原原位合金化法,制备出纳米γ--Ni--xFe (x = 20%~39%, 质量分数)合金,并通过XRD、TEM、SEM、BET等方法研究了材料的微观结构与制备条件的关系.结果表明: 当氢气还原原位合金化的温度为600~700℃时, 合金化完全,Ni--Fe合金的晶粒尺寸为15~55 nm, 平均颗粒尺寸小于100 nm;在30 K至室温范围内, 块体纳米Ni--Fe合金的各向异性磁电阻率(MR)随温度的降低线性地增加. 室温MR=0.98%, 在50K,MR值达8.7%, 高磁电阻的原因可能是纳米Ni--Fe合金强烈的磁相关界面散射.
关键词 金属材料Ni--Fe合金的磁电阻    
Key words
收稿日期: 1900-01-01     
1 M.F.Ashby,T.J.Lu,Metal foams:A survey,Science in China(B),46(6),521(2003)
2 J.Banhart,Manufacture,characterization and application of cellular metals and metal foams,Progress in Materials Science,46(6),559(2001)
3 HE Deping,MA Liqun,YU Xingquan,The heat transfer characteristics of foamed metal with open pore,Chinese Journal of Materials Research,11(4),432(1997) (何德坪,马立群,余兴泉,新型通孔泡沫铝的传热特性,材料研究学报,11(4),432(1997))
4 J.S.Noh,K.B.Lee,C.G.Lee,Pressure loss and forced con- vective heat transfer in an annulus filled with aluminum foam,International Communications in Heat and Trans- fer,33,434(2006)
5 K.Boomsma,D.Poulikakos,F.Zwick,Metal foams as com- pact high performance heat exchangers,Mechanics of Ma- terials,35,1161(2003)
6 ZHANG Houlei,TAN Junjie,ZHANG Lixin,Measure- ment of volumetric convective heat transfer coefficient in porous aluminum,Journal of Chemical Industry and En- gineering(China),55(10),1710(2004) (张后雷,谭俊杰,章立新,多孔铝内体积对流传热系数的测量,化工学报,55(10),1710(2004))
7 HE Deping,WEN Desun,ZHANG Yong,SHU Guangji, The infiltration process of molten Al into porous media, Chinese Journal of Materials Research,11(2),113(1997) (何德坪,闻德荪,张勇,舒光冀,铝熔体在多孔介质中的渗流过程,材料研究学报,11(2),113(1997))
8 ZHANG Weikai,LI Naizhe,HE Deping,Preparation of porous Al with high porosity by infiltration method,The Chinese Journal of Nonferrous Metals,15(8),1248(2005) (张伟开,李乃哲,何德坪,渗流法制备高孔隙率多孔铝,中国有色金属学报,15(8),1248(2005))
9 CAO Yuzhang,QIU Xuguang,Experimental Heat Trans- fer (Beijing,National Defence Industry Press,1998) p.234 (曹玉璋,邱绪光,实验传热学(北京,国防工业出版社,1998) p.234)
10 X.Fu,R.Viskanta,J.P.Gore,Measurement and correlation of volumetric heat transfer coefficients of cellular ceramics, Experimental Thermal and Fluid Science,17,285(1998)
11 DU Jianhua,WANG Buxuan,Research on the forced con- vective heat transfer for fluid flow through porous media with internal heat source,Journal of Engineering Thermo- physics,20(1),69(1999) (杜建华,王补宣,带内热源多孔介质中的受迫对流换热,工程热物理学报,20(1),69(1999))
12 Fujio Kuwahara,Mitsuhiro Shirota,Akira Nakayama,A numerical study of interfacial convective heat transfer co- efficient in two-energy equation model for convection in porous media,International Journal of Heat and Mass Transfer,44,1153(2001)
13 P.X.Jiang,Z.P.Ren,Numerical investigation of forced con- vection heat transfer in porous media using a thermal non-equilibrium model,International Journal of Heat and Fluid Flow,22,102(2001)
14 LIN Ruital,Introduction to Heat and Mass Transfer in Porous Media (Beijing,Science Press,1995) p.53 (林瑞泰,多孔介质传热传质引论(北京,科学出版社,1995) p.53)
15 YANG Donghui,HE Deping,Porosity of porous Al alloys, Science in China(B),44(4),411(2001)
16 CHEN Feng,ZHANG Aiwen,HE Deping,Control of the degree of pore-opening for porous metals,Chinese Journal of Materials Research,13(6),591(1999) (陈锋,张爱文,何德坪,多孔金属通孔度的控制,材料研究学报,13(6),591(1999))
[1] 毛建军, 富童, 潘虎成, 滕常青, 张伟, 谢东升, 吴璐. AlNbMoZrB系难熔高熵合金的Kr离子辐照损伤行为[J]. 材料研究学报, 2023, 37(9): 641-648.
[2] 宋莉芳, 闫佳豪, 张佃康, 薛程, 夏慧芸, 牛艳辉. 碱金属掺杂MIL125CO2 吸附性能[J]. 材料研究学报, 2023, 37(9): 649-654.
[3] 赵政翔, 廖露海, 徐芳泓, 张威, 李静媛. 超级奥氏体不锈钢24Cr-22Ni-7Mo-0.4N的热变形行为及其组织演变[J]. 材料研究学报, 2023, 37(9): 655-667.
[4] 邵鸿媚, 崔勇, 徐文迪, 张伟, 申晓毅, 翟玉春. 空心球形AlOOH的无模板水热制备和吸附性能[J]. 材料研究学报, 2023, 37(9): 675-684.
[5] 幸定琴, 涂坚, 罗森, 周志明. C含量对VCoNi中熵合金微观组织和性能的影响[J]. 材料研究学报, 2023, 37(9): 685-696.
[6] 欧阳康昕, 周达, 杨宇帆, 张磊. LPSOMg-Y-Er-Ni合金的组织和拉伸性能[J]. 材料研究学报, 2023, 37(9): 697-705.
[7] 徐利君, 郑策, 冯小辉, 黄秋燕, 李应举, 杨院生. 定向再结晶对热轧态Cu71Al18Mn11合金的组织和超弹性性能的影响[J]. 材料研究学报, 2023, 37(8): 571-580.
[8] 熊诗琪, 刘恩泽, 谭政, 宁礼奎, 佟健, 郑志, 李海英. 固溶处理对一种低偏析高温合金组织的影响[J]. 材料研究学报, 2023, 37(8): 603-613.
[9] 刘继浩, 迟宏宵, 武会宾, 马党参, 周健, 徐辉霞. 喷射成形M3高速钢热处理过程中组织的演变和硬度偏低问题[J]. 材料研究学报, 2023, 37(8): 625-632.
[10] 由宝栋, 朱明伟, 杨鹏举, 何杰. 合金相分离制备多孔金属材料的研究进展[J]. 材料研究学报, 2023, 37(8): 561-570.
[11] 任富彦, 欧阳二明. g-C3N4 改性Bi2O3 对盐酸四环素的光催化降解[J]. 材料研究学报, 2023, 37(8): 633-640.
[12] 王昊, 崔君军, 赵明久. 镍基高温合金GH3536带箔材的再结晶与晶粒长大行为[J]. 材料研究学报, 2023, 37(7): 535-542.
[13] 刘明珠, 樊娆, 张萧宇, 马泽元, 梁城洋, 曹颖, 耿仕通, 李玲. SnO2 作散射层的光阳极膜厚对量子点染料敏化太阳能电池光电性能的影响[J]. 材料研究学报, 2023, 37(7): 554-560.
[14] 秦鹤勇, 李振团, 赵光普, 张文云, 张晓敏. 固溶温度对GH4742合金力学性能及γ' 相的影响[J]. 材料研究学报, 2023, 37(7): 502-510.
[15] 刘天福, 张滨, 张均锋, 徐强, 宋竹满, 张广平. 缺口应力集中系数对TC4 ELI合金低周疲劳性能的影响[J]. 材料研究学报, 2023, 37(7): 511-522.