Please wait a minute...
材料研究学报  2004, Vol. 18 Issue (2): 119-122    
  论文 本期目录 | 过刊浏览 |
退火温度对Nd2Fe14B/a-Fe磁性多层膜中相形成的影响
陈立军;贺连龙;刘伟;张志东
中国科学院金属研究所
Influence of annealing temperature on the phase transformation in the Nd2Fe14B/a--Fe nanocomposite mulitilayer films
;;;
中国科学院金属研究所
引用本文:

陈立军; 贺连龙; 刘伟; 张志东 . 退火温度对Nd2Fe14B/a-Fe磁性多层膜中相形成的影响[J]. 材料研究学报, 2004, 18(2): 119-122.
, , , . Influence of annealing temperature on the phase transformation in the Nd2Fe14B/a--Fe nanocomposite mulitilayer films[J]. Chin J Mater Res, 2004, 18(2): 119-122.

全文: PDF(1942 KB)  
摘要: 通过TEM和HRTEM对比研究了软磁层厚度为2.5 nm的Nd2Fe14B/a-Fe型多层膜的显微结构. 结果表明, 在退火前的多层膜中Fe层为多晶, 硬磁相以非晶的状态存在; 在600℃以上退火后软磁层消失, 生成的Nd2Fe14B型相被固定在硬磁层内; 625℃退火后发现有Nd2Fe17相在硬磁层中析出, 表明在多层膜退火过程中, 退火温度对相转变的影响比退火时间的影响更大. Nd2Fe17相的析出可能是高温退火后磁性能下降的主要原因.
关键词 : 金属材料,  纳米复合永磁材料,  磁性多层膜,  微    
Abstract:Microstructure of Nd2Fe14B/a-Fe-type multilayer films annealed at 600℃ for 5 min and annealed at 625℃ for 1 min with the same thickness of a--Fe layers (2.5 nm) have been investigated by TEM and HRTEM. The result showed that a-Fe nano-grains formed in Fe layers in the as--sputtered film, however, the hard magnetic phase remained amorphous state. When the annealing temperature was higher than 600℃, Nd2Fe14B type phases formed, the a--Fe layers were devoured by the hard magnetic layers, and Nd2Fe17 phases were found in another multilayer film annealed at 625℃. It implied that the annealing temperature played a more important role in the phase transformation than the annealing time. The decrease of magnetic properties maybe resulted from the separating out of Nd2Fe17 phase.
Key words: metallic materials    nanocomposite permanent magnets    multilayer films    microstructure    exchange coupling
收稿日期: 2004-05-21     
ZTFLH:  TM271  
1 R.Coehoom,D.B.de Mooij, C.De.Waard, J. Magn. Magn. Mater, 80,101(1989)
2 E.F.Kneller,R.Hawig,IEEE Trans.on Magn., 27, 3588(1991)
3 R.Skomski,J.M.D.Coey,Phys.Rev.B,B48,15812(1993)
4 J.Ding,P.G.Mccorrmick,R.Street,J.Magn.Magn.Mater.,124,1(1993)
5 I.Panagiotopoulos,L.Withanawasam,A.S.Murthy,G.C.Hadjipanayis,E.W.Singleton,D.J.Sellmyer,J.Appl.Phys.,79,4827(1996)
6 L.Withanawasam,G.C.Hadjipanayis,R.F.Krause,J.Appl.Phys.,75,6646(1994)
7 A.Manaf,R.A.Buckley,H.A.Davies,J.Magn.Magn.Mater.,128,302(1993)
8 D.Goll,M.Seeger,H.Kronmuller,J.Magn.Magn.Mater.,185,49(1998)
9 I.A.Al-Omari,D.J.Sellmyer,Phys.Rev.B,52,3441(1995)
10 W.Liu,Z.D.Zhang,J.P.Liu,L.J.Chen,L.L.He,Y.Liu,X.K.Sun,D.J.Sellmyer,Adv.Mater.,14,1832(2002)
11 C.Y.You,C.J.Yang,Z.D.Zhang,J.S.Han,W.Liu,X.K.Sun,J.Phys.D-Appl.Phys.,36,423(2003)
12 B.Z.Cui, M.J.O'Shea, J. Magn. Magn. Mater., 256, 348(2003)
13 J.L.Tsai, T.S.Chin, Y.D.Yao, H.Kronmuller, J. Appl. Phys., 91, 8177(2002)
14 M.Yu, Y.Liu, S.H.Liou, D.J.Sellmyer, J. Appl. Phys., 83, 6611(1998)
[1] 毛建军, 富童, 潘虎成, 滕常青, 张伟, 谢东升, 吴璐. AlNbMoZrB系难熔高熵合金的Kr离子辐照损伤行为[J]. 材料研究学报, 2023, 37(9): 641-648.
[2] 宋莉芳, 闫佳豪, 张佃康, 薛程, 夏慧芸, 牛艳辉. 碱金属掺杂MIL125的CO2 吸附性能[J]. 材料研究学报, 2023, 37(9): 649-654.
[3] 赵政翔, 廖露海, 徐芳泓, 张威, 李静媛. 超级奥氏体不锈钢24Cr-22Ni-7Mo-0.4N的热变形行为及其组织演变[J]. 材料研究学报, 2023, 37(9): 655-667.
[4] 邵鸿媚, 崔勇, 徐文迪, 张伟, 申晓毅, 翟玉春. 空心球形AlOOH的无模板水热制备和吸附性能[J]. 材料研究学报, 2023, 37(9): 675-684.
[5] 幸定琴, 涂坚, 罗森, 周志明. C含量对VCoNi中熵合金微观组织和性能的影响[J]. 材料研究学报, 2023, 37(9): 685-696.
[6] 欧阳康昕, 周达, 杨宇帆, 张磊. 含LPSO相Mg-Y-Er-Ni合金的组织和拉伸性能[J]. 材料研究学报, 2023, 37(9): 697-705.
[7] 潘新元, 蒋津, 任云飞, 刘莉, 李景辉, 张明亚. 热挤压钛/钢复合管的微观组织和性能[J]. 材料研究学报, 2023, 37(9): 713-720.
[8] 徐利君, 郑策, 冯小辉, 黄秋燕, 李应举, 杨院生. 定向再结晶对热轧态Cu71Al18Mn11合金的组织和超弹性性能的影响[J]. 材料研究学报, 2023, 37(8): 571-580.
[9] 熊诗琪, 刘恩泽, 谭政, 宁礼奎, 佟健, 郑志, 李海英. 固溶处理对一种低偏析高温合金组织的影响[J]. 材料研究学报, 2023, 37(8): 603-613.
[10] 刘继浩, 迟宏宵, 武会宾, 马党参, 周健, 徐辉霞. 喷射成形M3高速钢热处理过程中组织的演变和硬度偏低问题[J]. 材料研究学报, 2023, 37(8): 625-632.
[11] 由宝栋, 朱明伟, 杨鹏举, 何杰. 合金相分离制备多孔金属材料的研究进展[J]. 材料研究学报, 2023, 37(8): 561-570.
[12] 任富彦, 欧阳二明. g-C3N4 改性Bi2O3 对盐酸四环素的光催化降解[J]. 材料研究学报, 2023, 37(8): 633-640.
[13] 王昊, 崔君军, 赵明久. 镍基高温合金GH3536带箔材的再结晶与晶粒长大行为[J]. 材料研究学报, 2023, 37(7): 535-542.
[14] 刘明珠, 樊娆, 张萧宇, 马泽元, 梁城洋, 曹颖, 耿仕通, 李玲. SnO2 作散射层的光阳极膜厚对量子点染料敏化太阳能电池光电性能的影响[J]. 材料研究学报, 2023, 37(7): 554-560.
[15] 秦鹤勇, 李振团, 赵光普, 张文云, 张晓敏. 固溶温度对GH4742合金力学性能及γ' 相的影响[J]. 材料研究学报, 2023, 37(7): 502-510.