|
|
Effects of Annealing Time on Microstructure and Mechanical Properties of Continuous Casting Weathering Steel Containing 0.15%P Thin Cold-rolled Strip |
CHEN Jun1, ZHOU Guoping2, LIU Zhenyu1, QIU Yiqing1, WANG Guodong1 |
1.The state Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004
2.Tangshan Iron & Steel Co. Ltd, Cold Rolling Plant, Tangshan 063016 |
|
Cite this article:
CHEN Jun ZHOU Guoping LIU Zhenyu QIU Yiqing WANG Guodong. Effects of Annealing Time on Microstructure and Mechanical Properties of Continuous Casting Weathering Steel Containing 0.15%P Thin Cold-rolled Strip. Chin J Mater Res, 2011, 25(3): 268-272.
|
Abstract The weathering strip containing 0.15%P was prepared by using a pilot twin-roll strip caster. The effect of annealing time on microstructure and mechanical properties of the continuous casting weathering steel after cold rolling was investigated. The results show that after annealing for 40 min the fine ferrite and pearlite structure can be gained and all of yield ratios are less than 0.8 and all of strain hardening exponents are higher than 0.2 during the annealing times which were investigated in the paper. Tensile strength gradually declines and yield strength firstly descends and basically remains invariant subsequently with annealing time increasing. The reason that fine grain structure can be observed in localized area was discussed.
|
Received: 06 January 2011
|
|
Fund: Supported by National Key Basic Research and Development Program of China No.2004CB619108. |
1 G.Xu, F.Yin, K.Nagai, Solidification cooling rate and ascast texture of low-carbon steel strips, Mater Sci Eng A, 441(1-2), 157(2006)2 Han S. Kim, Y. Kobayashi, S. Tsukamoto, K. Nagai, Effect of cooling rate on microstructure evolution of rapidly cooled high-impurity steels, Mater Sci Eng A, 403(1-2), 311(2005)3 R.Wechsler, The status of twin-roll casting technology, Scandinavian Journal of Metallurgy, 32, 58(2003)4 ZHAO Hongyang, HU Lin, LI Na, Development of twohigh thin strip casting and rolling technology and key point review, Angang Technology, 6, 1(2007) (赵红阳, 胡林, 李娜, 双辊薄带铸轧技术的进展及热点问题评述, 鞍钢技术, 6, 1(2007))5 LIU Zhenyu, ZHOU Guoping, QIU Yiqing, WANG Guodong, Inversed phosphorus segregation in twin roll cast strips for improvement of mechanical properties and weathering resistance, ISIJ International, 50(4), 531(2010)6 LI Na, LIU Zhenyu, QIU Yiqing, WANG Guodong, in: International Conference on Advanced Structural Steels, P and Cu segregation behavior in strip cast low C steel, Korea, 2006, p.9647 LIU Zhenyu, LIN Zhaosen, QIU Yiqing, LI Na, LIU Xianghua, WANG Guodong, Segregation in twin roll strip cast steels and the effect on mechanical properties, ISIJ, 54, 254(2007)8 ZANG Ershou, WANG Wenxin, P-segregation behavior in heavy-rail carbon steel, Journal of Northeastern University(Natural Science), 12(4), 366(1991)(臧尔寿, 王文新, 碳素重轨钢中磷的偏聚行为, 东北大学学报(自然科学版), 12(4), 366(1991))9 ZHOU Guoping, CHEN Jun, LIU Zhenyu, QIU Yiqing, WANG Guodong, Effect of annealing temperature on mechanical properties of casting strip steel with high phosphorus after cold rolling, Steel Rolling, 27(4), 25(2010)(周国平, 陈俊, 刘振宇, 邱以清, 王国栋, 退火温度对铸轧高磷钢冷带力学性能的影响, 轧钢, 27(4), 25(2010))10 QIAO Lifeng, LIU Zhenyu, WANG Guodong, ZHANG Hongmei, Effect of annealing time on the microstructure and properties of Nb-bearing high-strength IF steel with super-fine grains, Journal of University of Science and Technology Beijing, 32(8), 998(2010)(乔立峰, 刘振宇, 王国栋, 张红梅, 退火时间对含铌高强细晶IF钢组织性能的影响, 北京科技大学学报, 32(8), 998(2010))11 K.W.Andrews, Empirical formulae for the calculation of some transformation temperature, Iron Steel Inst, 203(6), 721(1965) |
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|