Chinese Journal of Materials Research
Home
IMR Journals
Subscription
Contact us
中文
Search
Citation
Fig/Tab
adv Search
Just Accepted
|
Current Issue
|
Archive
|
Featured Articles
|
Special Issue
|
Most Read
|
Most Downloaded
|
Most Cited
ISSN 1005-3093
CN 21-1328/TG
Started in 1987
About the Journal
»
About Journal
»
Editorial Board
»
Indexed in
»
Fund
»
Rewarded
Authors
»
Online Submission
»
Guidelines for Authors
»
Copyright Agreement
Reviewers
»
Guidelines for Reviewers
»
Online Peer Review
»
Online Editor Work
Office
»
Editor-in-chief
»
Office Work
Current Issue
, Volume 4 Issue 3
Previous Issue
Next Issue
For Selected:
View Abstracts
Download Citations
EndNote
Reference Manager
ProCite
BibTeX
RefWorks
Select
THE MICROSTRUCTURE OF SOME LOW DIMENSIONAL MATERIALS(1)——Ultrafine Carbonyl Iron Powders and Laser-made SiCB Powders
LIN Xiwei;ZHU Jing(Central Iron and Steel Research Institute;Ministry of Metallurgical Industry)NING Xiaoguang;YE Hengqiang(Institute of Metal Research;Academia sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 193-199.
Abstract
PDF
(2190KB) (
754
)
The carbonyl iron ultrafine powders(UFCIP)of the size ranging from 5 to30nm and the laser-made SiCB ultrafine powders of the size ranging from 30 to 80nmwere characterized by CTEM,EELS,HREM and microdiffraction.It was found that thecarbonyl iron ultrafine
References
|
Related Articles
|
Metrics
Select
FINE STRUCTURE AND CRYSTALLOGRAPHY OF THE MICROSTRUCTURES IN A NORMALIZED 55SiMnMo STEEL
LUO Chengping;LIU Zhengyi;XU Linkang(South-China University of Technology)
Chinese Journal of Materials Research, 1990,
4
(3): 200-205.
Abstract
PDF
(2209KB) (
847
)
The microstructures produced in a normalized 55SiMnMo steel consisted ofcarbide-free upper and lower bainite,martensite and retained austenite.Both the upperand lower bainite contained midribs,subunits and dislocations;the martensite was twinned;and the r
References
|
Related Articles
|
Metrics
Select
THE DISLOCATIOIN-FREE ZONE AHEAD OF THE CRACK TIP IN BULK ALUMINIUM SINGLE CRYSTALS
WANG Xiuhua;LI Jian;AN Zhengzhi;HA Kuanfu(Jilin University)XU Yongbo(Institute of Metal Research;Academia Sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 206-211.
Abstract
PDF
(1778KB) (
844
)
After loading a distocation-free zone(DFZ)was found in model Ⅰprecracked bulk Al single crystals.It was shown by analysis that DFZ has its own threedimensional characteristics,this conclusion was verified directly by a Pseudo Kossel meth-od.A new formatio
References
|
Related Articles
|
Metrics
Select
EFFECT OF MISCH METAL ON THE HOT PLASTICITY OF AN Al-Mg-Si ALLOY
ZHOU Shouze;PAN Fusheng;DING Peidao;LIU Jingyuan;SHI Gongqi(CHongqing University)
Chinese Journal of Materials Research, 1990,
4
(3): 212-217.
Abstract
PDF
(894KB) (
823
)
The effects of the addition of misch metal on the hot plasticity andmicrostructure of an Al-Mg-Si alloy(6063)have been investigated by using the hottorsional test,SEM and TEM.The results show that the hot plasticity of the 6063 alumi-num alloy is obviousl
References
|
Related Articles
|
Metrics
Select
THE DISLOCATION ARRANGEMENT AND INTERFACE STRUCTURE OF PEARLITE IN AN EUTECTOID STEEL
HUANG Xiaoying;XU Haigang(Centra Iron and Steel Research Institute;Ministry of Metallurgical Industry)
Chinese Journal of Materials Research, 1990,
4
(3): 218-222.
Abstract
PDF
(608KB) (
802
)
An investigation of the fracture path of pearlite,dislocation arragement andinterface structure of the two phases in an eutectoid pearlitic steel have been carried out bymeans of TEM and SEM.Both in proeutectoid ferrite and in the ferrite of the pearlite,
References
|
Related Articles
|
Metrics
Select
DEVELOPMENT OF SHORT CARBON FIBER-COPPER COMPOSITE
ZHANG Xiaojun;YING Meifang;WANG Chengfu(Hefei University of Technology)
Chinese Journal of Materials Research, 1990,
4
(3): 223-227.
Abstract
PDF
(1070KB) (
767
)
Short cabon fiber-copper composite were made by means of powder me-tallurgy.The fibers in composite were homgeneously distributed in the matrix and orientedrandomly.The tensile strength of the composite increases as the volume of fiber from 0 to2%,but dec
References
|
Related Articles
|
Metrics
Select
A HIGH SPEED CINEMATOGRAPHY STUDY OF RAPID SOLIDIFICATION
YANG Gencang;WEI Bingbo;ZHOU Yaohe(Northwestern Polytechnical University)
Chinese Journal of Materials Research, 1990,
4
(3): 228-231.
Abstract
PDF
(424KB) (
822
)
Ni-32.5%Sn eutectic alloy has been undercooled by up to 302K(0.215T_E)throughdenucleating with a special boron-silicate glass 70% Na_2SiO_3+17.7% Na_2B_4O_7+12.3%B_2O_3.Its rapidsolidification behaviour during recalescence was studied by means of high spe
References
|
Related Articles
|
Metrics
Select
M_2C CARBIDE IN M2 HIGH SPEED TOOL STEEL
LUO Di;XING Guohua;LI Wencheng;LIAO Xin(Central Iron and Steel Research Institute;Ministry of Metallurgical Industry)
Chinese Journal of Materials Research, 1990,
4
(3): 232-236.
Abstract
PDF
(1350KB) (
776
)
M_2C carbide and its decomposition products have been studied by SEM.Inthe cast state,the morphology of M_2C on the grain boundies is like″fan″,″lameller″or″stranger″.M_2C carbide is metastable at high temperature and will normally decompose toMC and M_6C
References
|
Related Articles
|
Metrics
Select
EFFECT OF HYDROGEN ON THE DIFFUSION OF Al AND V IN PURE TITANTUM
ZHAO Linruo;ZHANG Shaoqing;YAN Minggao(Institute of Aeronautical Materials;Beijing)
Chinese Journal of Materials Research, 1990,
4
(3): 237-240.
Abstract
PDF
(276KB) (
826
)
The effect of hydrogen on the diffusion of Al and V in pure titanium wereinvestigated by diffusion couple experiments.It was shown that hydrogen can enhance thediffusivities of both Al and V.An order of increasing the diffusivity of Al has beenobtained.Th
References
|
Related Articles
|
Metrics
Select
FRACTAL DIMENSION OF FRACTURE SURFACE FORMED BY SLOW CRACK PROPAGATON INDUCED BY HYDROGEN
LONG Qiyi;LI Suqing;LONG Qiwei(C.W.LUNG)(Institute of Metal Research;Academia Sinica)(International Centre for Materials Physics;Academia Sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 241-246.
Abstract
PDF
(717KB) (
705
)
Fractal dimension of different parts of a fracture surface formed by slowcrack propagation induced by the combining effect of hydrogen and static bending momentwere determined by using the method of fracture profile analysis.The results show that thefract
References
|
Related Articles
|
Metrics
Select
FRACTAL STRUCTURES ALONG DIFFERENT DIRECTIONS OF FRACTURED SURFACES
MU Zaiqin;LI Shuqing;LONG Qiwei(C.W.Lung)(Institute of Metal research;Academia Sinica)(International Centere for Materials physis Academia Sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 247-250.
Abstract
PDF
(272KB) (
756
)
The vertical section method is employed to measure fractal dimensions ofcross section profile of fractured surfaces under plane strain conditions.It is shown that thevertical section method could describe further the roughness of fractured surfaces as com
References
|
Related Articles
|
Metrics
Select
MORPHOLOGY AND MICROSTRUCTURE OF YBaCuO SUPERCONDUCTING THIN FILMS
LI Lin;WANG Huisheng;LIU Wei(Institute of Physics;Academia Sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 251-256.
Abstract
PDF
(1615KB) (
813
)
The morphology and microstructure of YBaCuO superconducting thinfilms deposited on sapphire,ZrO_2 and SrTiO_3 single crystal by RF magnetron reactivesputtering were studied by SEM and TEM.The relationship between the microstructureand the superconductivit
References
|
Related Articles
|
Metrics
Select
Néel TRANSITION OFγ-Fe-Mn-Ge ALLOYS
ZHANG Yansheng(Dalian railway Iustitute)ZENG Hongbin(Institute of Metal research;Academia Sinica)
Chinese Journal of Materials Research, 1990,
4
(3): 257-260.
Abstract
PDF
(294KB) (
744
)
The effects of Ge content(0—8.7at-%)on the Neel transition of γ-Fe-Mn alloys havebeen investigated by magnetic susceptibility(χ)measurement and M(?)ssbauer spectrum anlysis.With in-creasing Ge content,the magnetic susceptibility increases and the Neel tem
References
|
Related Articles
|
Metrics
Select
DELAMINATION CHARACTERIZATION OF A UNINDIRECTIONAL LAMINATE WITH INSIDE PLIES CUT
DENG Meng;XI Niansheng(Institute of Aeronautical Materials)R.Prize(Institute for Structureal Mechanics;DEVLR;Federal Germany)
Chinese Journal of Materials Research, 1990,
4
(3): 261-264.
Abstract
PDF
(245KB) (
765
)
Stress-controlled tension-tension fatigue tests(R=0.1,σ_u=275,325,375MPa)were per-formed on 914C/TS-5 graphite/epoxy laminates of(O_2, Φ_2)_s stacking order.Some of layers in thelaminates were cut in order to create a favourable condition for mode Ⅱ fract
References
|
Related Articles
|
Metrics
Select
APPARENT TRANSFER PHENOMENA FOR Ti AND Si IN MOLTEN Cu-Ti-Si ALLOYSN
XUE Xiangxin;DU Hegui(Northeast University of Technology)
Chinese Journal of Materials Research, 1990,
4
(3): 265-268.
Abstract
PDF
(211KB) (
703
)
An experimental study has been made on the apparent transfer phenomena for Ti and Si inmolten Cu-Ti-Si alloys contacted with TiO_2 and SiO_2 by a constant P_(H_2O)/P_(H_2)at 1500℃.Linear rela-tions between apparent mass-transfer coefficients k′_(Ti) and k
References
|
Related Articles
|
Metrics
Select
GROWTH OF DIAMOND FILMS BY LOWER PRESSURE PHASE
ZHANG Baojun;HUANG Suiyang;CANG Fengbo;CHANG Jingyi(China Building Materials Academy)
Chinese Journal of Materials Research, 1990,
4
(3): 269-272.
Abstract
PDF
(859KB) (
725
)
Vacuum evaporating device which was designed by us is used to grow dia-mond films on the substrate of silicon single crystals from a mixture of CH_4 and H_2 gasesat lower pressure by hot-filament CVD method.The results of X-ray diffraction,Ramanspectrum a
References
|
Related Articles
|
Metrics
Select
PROPERTIES OF SURFACE AND WHISKER-LIKE MICROSTRUCTURES OF AMORPHOUS SILICON
LIN Hongyi(Beijing Institute of Technology)
Chinese Journal of Materials Research, 1990,
4
(3): 273-276.
Abstract
PDF
(638KB) (
805
)
The surface,the interface and the microstructures of the undoped hydrogenated amorphoussilicon films by RF plasma chemical vapor deposition are investigated.The whisker-like microstructures(amorphous silicon whisker)are observed by transmission electron m
References
|
Related Articles
|
Metrics
Select
CRYSTAL MORPHOLOGY AND TENSILE BEHAVIORS OF PHOTOCROSSLINKED POLYETHYLENE
XU Wenying;YAN Qing;B.R(?)nby(University of Science and Technology of China)
Chinese Journal of Materials Research, 1990,
4
(3): 277-280.
Abstract
PDF
(262KB) (
679
)
The structure and properties of photocrosslinked polyethylene inLDPE-BP-TAIC system were studied.The results of X-ray diffraction and DSCmeasurement show that the effect of crosslinking of the crystallinity was very limited,butthe crosslinks can affect th
References
|
Related Articles
|
Metrics
Select
ANOMALOUS MORPHOLOGY OF COMPOSITE POLYMER EMULSION PARTICLES
CHENG Guoxiang;SHENGJing;YAO Kangde(Tianjin University)
Chinese Journal of Materials Research, 1990,
4
(3): 281-283.
Abstract
PDF
(577KB) (
852
)
″Raspberrylike″and″Void″composite polymer paritcle were prepared by seeding emulsionpolymerization.The formative reasons of the morphology are inferred.It is considered that the hydrophilicdifference is primary factor to control the morphology.
References
|
Related Articles
|
Metrics
Select
(Fe,Co,Ni)B Systems Ultra Fine Amorphous Powders BY Chemical Reduction
No Author
Chinese Journal of Materials Research, 1990,
4
(3): 284-284.
Abstract
PDF
(171KB) (
605
)
References
|
Related Articles
|
Metrics
News
More
»
2011年金属所期刊联合征订启事
2010-07-30
Links
More