Chinese Journal of Materials Research
Home
IMR Journals
Subscription
Contact us
中文
Search
Citation
Fig/Tab
adv Search
Just Accepted
|
Current Issue
|
Archive
|
Featured Articles
|
Special Issue
|
Most Read
|
Most Downloaded
|
Most Cited
ISSN 1005-3093
CN 21-1328/TG
Started in 1987
About the Journal
»
About Journal
»
Editorial Board
»
Indexed in
»
Fund
»
Rewarded
Authors
»
Online Submission
»
Guidelines for Authors
»
Copyright Agreement
Reviewers
»
Guidelines for Reviewers
»
Online Peer Review
»
Online Editor Work
Office
»
Editor-in-chief
»
Office Work
Current Issue
, Volume 5 Issue 4
Previous Issue
Next Issue
For Selected:
View Abstracts
Download Citations
EndNote
Reference Manager
ProCite
BibTeX
RefWorks
Select
RELATIONSHIPS BETWEEN DEGREE OF UNDERCOOLING IN SOLIDFICATION AND THERMAL PROPERTIES OF METALS
LIANG Guoxian WANG Erde HUO Wencan (Harbin Institute of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 277-283.
Abstract
PDF
(435KB) (
833
)
Equations between degree of undercooling and thermal properties of metalsin homogeneous nucleation,non-homogeneous nucleation and solidification under pres-sure have been established.Based on conventional data of thermal properties of metals,theexperiment
References
|
Related Articles
|
Metrics
Select
INTERACTION BETWEEN Al_2O_3 PARTICLE AND THE SOLID-LIQUID INTERFACE OF ALUMINIUM ALLOY
LIU Yaohui HE Zhenming DONG Guitian (Jilin University of Technology)LI Qingchun (Harbin University of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 284-289.
Abstract
PDF
(866KB) (
747
)
The interaction between Al_2O_3 particle and the growing solid-liquid inter-face in Al_2O_3 particle/A1-2.OMg-4.5Cu alloy composite during solidification is investi-gated by means of directional solidification technique in this paper.The distribution lawa
References
|
Related Articles
|
Metrics
Select
INFLUENCE OF Mn ON RHEOLOGICAL BEHAVIOR OF Al-5wt-%Cu ALLOY IN SOLID-LIQUID COEXISTENCE ZONE
CHEN Kuiying ZENG Songyan LI Qingchun (Harbin Institute of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 290-293.
Abstract
PDF
(261KB) (
759
)
Influence of Mn on rheological behavior of Al-5wt-%Cu alloy insolid-liquid coexistence zone (SLCZ) has been investigated on apparatus specially de-signed.Results show that Mn makes shear modulus,viscosity and yield strength of alloys inSLCZ raise to some
References
|
Related Articles
|
Metrics
Select
THERMODYNAMICS OF THE MARTENSITIC TRANSFORMATION IN Cu-Zn-Al ALLOYS
ZHOU Xiaowang XU Zuyao(T.Y.Hsu) (Shanghai Jiao Tong University)
Chinese Journal of Materials Research, 1991,
5
(4): 294-300.
Abstract
PDF
(467KB) (
755
)
The equilibrium temperatures of the disordered α and β phases T_0and ofthe ordered α′and β′(L2_1structure)T_0,as well as the M_s(β′assumed to be B2,DO_3,andL2_1structure respectivety)have been calculated thermodynamically for Cu-Zn-Al alloyswith various c
References
|
Related Articles
|
Metrics
Select
THE BAINITIC BASIC UNITS AND THEIR GROWTH EVOLUTION IN FERROUS ALLOYS
XU Qikun ZHOU Zheng (Chongqing University)
Chinese Journal of Materials Research, 1991,
5
(4): 301-307.
Abstract
PDF
(3701KB) (
832
)
The structure morphologies of products formed in the earlier stage of inter-mediate transformation in the experimental alloys Fe-C-Mo and Fe-C-Si-Mn have beeninvestigated with TEM.It was found that in whole intermediate temperature range thetransformation
References
|
Related Articles
|
Metrics
Select
IN-SITU OBSERVATIONS ON DISLOCATION BEHAV IOR AND THE EFFECT OF HYDROGEN NEAR THE CRACK-TIP IN Fe-3%Si SINGLE CRYSTAL BY TEM
SUI Guoxin XU Yongbo ZHOU Jing HA Kuanfu WANG Zhongguang (Institute of Metal Research;Academia Sinica;Jilin University)
Chinese Journal of Materials Research, 1991,
5
(4): 308-314.
Abstract
PDF
(2483KB) (
802
)
Dislocation behavior and effect of hydrogen have been observed near thecrack-tip in Fe-3%Si single crystal during in-situ deformation in an electron microscope.It has been found that a number of dislocations were emitted from the crack-tip duringdeformati
References
|
Related Articles
|
Metrics
Select
RELATIONSHIP BETWEEN SUPERPLASTICITY OF 7475Al AND FRACTAL DIMENSION OF FRACTURE SUR-FACE MEASURED BY VERTICAL SECTION METHOD
JIANG Xingang CUI Jianzhong MA Longxinag (University of Science and Technology Beijing)(Northeast University of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 315-319.
Abstract
PDF
(1016KB) (
794
)
Fractal dimensions of fracture surfaces of 7475 Al were measured by verticalsection method when the alloy was deformed under different temperaute,strain rate andgrain size.The results show that the higher the fractal dimension of fracture surface,thelarge
References
|
Related Articles
|
Metrics
Select
STRUCTURE AND WEAR BEHAVIOUR OF NITROGEN-IMPLANTED ALUMINUM ALLOYS
WANG Rizhi XIA Lifang (Harbin Institute of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 320-325.
Abstract
PDF
(1425KB) (
790
)
Aluminum alloys L2,LD2,LF12,LY12,AI-4%Cu were implanted with ni-trogen ions at energy of 80keV at room temperature and dose range of 1×10~(16)—8.3×10~(17)N~+·cm~(-2).The surface structure,chemical bond of the implanted surafce layer were in-vestigated by
References
|
Related Articles
|
Metrics
Select
SCALING CHARACTERISTICS IN THE STRENGTH OF POROUS PLATES
FU Ran LONG Qiyi LONG Qiwei (Institute of Metal Research;Academia Sinica)(International Center for Materials Physics;Academia Sinica)
Chinese Journal of Materials Research, 1991,
5
(4): 326-330.
Abstract
PDF
(372KB) (
741
)
We performed the measurements of the bulk modulus E,yield strength S_y,fracture strength S and fracture work W in randomly punched plates of plexiglass,steeland aluminium.A power law relation is observed for E,S_y,and S near the percolationthreshold and t
References
|
Related Articles
|
Metrics
Select
SUPERPLASTICITY INDUCED BY DYNAMIC RECRYSTALLIZATION IN COMMERCIAL ALUMINIUM ALLOY LY12
YANG Guang ZENG Xianwen LIAN Jianshe LIU Yuwen LI Zhang (Jilin University of Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 331-335.
Abstract
PDF
(1300KB) (
783
)
The superplasticity induced by dynamic recrystallization in commercial al-uminium alloy LY12Y was studied.LY12Y sheet can exhibit suppertasticity in a wide rangeof temperature and strain rate in receipt condition.The maximum elongation of 243% wasobtained
References
|
Related Articles
|
Metrics
Select
FRACTURE BEHAVIOUR OF BAMBOO
XIAN Xingjuan XIAN Dingguo (Institute of Mechanics;Academia Sinica)(Hong Kong Polytechnic Institute)
Chinese Journal of Materials Research, 1991,
5
(4): 336-341.
Abstract
PDF
(1782KB) (
758
)
Bamboo is a species of abundant natural plant materials with highspecific-strength and high specific-modulus.This paper is concerned with fracturebehaviour of Phyllostachys and Bambusoides with notch at different face.Bending fracturetests were carried ou
References
|
Related Articles
|
Metrics
Select
INFLUENCE OF TOUGHENING TREATMENT ON IN-SULATOR-METAL TRANSITION AND MECHANICAL PROPERTIES OF VO_2 CERAMICS
YANG Zhaohui LUO Yuji ZHENG Chenmou ZHANG Jinxiu (Zhongshan University)
Chinese Journal of Materials Research, 1991,
5
(4): 342-345.
Abstract
PDF
(1079KB) (
876
)
VO_2 powder and VO_2 ceramics are prepared by diamine hydrochloridemethod and typical ceramic technology respectively.A insulator (monoclinic) to metal(tetragonai)transition with an abrupt decrease of electric resistance is observed around70℃.The variatio
References
|
Related Articles
|
Metrics
Select
STUDIES ON THE TRANSESTERIFICATION REACTION OF PBT/PC BLENDS OCCURING DURING MELT MIXING
CHEN Weixiao CHENG Song (Fudan University)
Chinese Journal of Materials Research, 1991,
5
(4): 346-351.
Abstract
PDF
(506KB) (
751
)
The transesterification reactions occuring during melt mixing ofpoly(butylene terephthalate)(PBT)with polycarbonate(PC)which both made in our coun-try are studied by intrinsic viscosity measurements,solubility separations,IR spectroscopyand selective degr
References
|
Related Articles
|
Metrics
Select
STUDY ON THE ULTIMATE FRACTURE STRENGTH AND FRACTURE BEHAVIOR OF POLYMERIC MATERIALS——Ⅳ.A Kinetic MOdel Theory Of Yielding Under Constant Rate Extension
SONG Mingshi JIANG Shuchun WU Lixin (Beijing Institute of Chemical Technology)ZHU Qingren (Chinese University of Science and Technolog)
Chinese Journal of Materials Research, 1991,
5
(4): 352-357.
Abstract
PDF
(449KB) (
776
)
The yielding phenomena of viscoelastic materials consist of three factors:1)the time dependence of the bulk stress-strain relation;2)the time dependence of the yield-ing initation mechanism;and 3)the kinetics of the molecular flow and bond rupture of theo
References
|
Related Articles
|
Metrics
Select
MANUFACTURE AND PROPERTIES OF CARBON FIBER REINFORCED MACHINEABLE PHLOGOPITE BASED GLASSCERAMIC MATRIX COMPOSITE(CPMC)
LIN Guangxin LIN Yongwei WU Xuqin ZHU Peinan ZHANG Yuanmin (East China University of Chemical Technology)
Chinese Journal of Materials Research, 1991,
5
(4): 358-361.
Abstract
PDF
(317KB) (
939
)
Phlogopite based glass-ceramic KM_(g3)(AlSi_2O_(10))F_2 is one kind ofbritttle,machineable ceramic material.Its brittle and mechanics properties are obviously im-proved after reinforced by carbon fiber to form composite (CPMC) which remainsmachineable.Thr
References
|
Related Articles
|
Metrics
Select
SIZE REQUIREMENT FOR K_(1c) MEASUREMENT
BAO Yiwang JIN Zongzhe (China Building Materials Academy)
Chinese Journal of Materials Research, 1991,
5
(4): 362-367.
Abstract
PDF
(397KB) (
838
)
In this paper,it is discovered that the basic hypothesis of fracture mechanics,K_(1c)=σ_f(ay)~(1/2) being a constant,is untenable when the crack size is smaller than certain val-ue which related to the material behavior.Thus,the measuring results with sma
References
|
Related Articles
|
Metrics
News
More
»
2011年金属所期刊联合征订启事
2010-07-30
Links
More